Home Automation Installation
One System, Installed and Programmed by One Company
A home automation installation ties your lighting, shades, climate, security and entertainment into a single system, so you're not switching between six apps to lock a door or dim a room. Low Voltage Components designs, wires and programs these systems for homes and businesses throughout San Diego's North County, working under a California C-7 low-voltage license (#1056087). Every project starts with a walk-through — what rooms, what systems, what's already there — because a one-room lighting setup is a very different project than a whole-house system, and you deserve a straight answer on cost and timeline before any wire gets pulled.
Built on a Network That Holds Up
The network is where most smart homes quietly fail. Wi-Fi dead zones, or a single access point covering two stories, will make lighting scenes lag and cameras drop — which is why Low Voltage Components designs the network alongside the automation itself, and why homes with thick stucco walls or detached casitas almost always need more than one access point. Security runs on that same backbone rather than a separate app, so one "away" scene locks the doors, drops the shades and turns on exterior lighting instead of three steps done by hand.
Wired In From the Framing
Unused cable run during framing costs a fraction of opening a wall later to add it, so Low Voltage Components works alongside builders during new construction to run Ethernet, speaker wire and conduit to rooms that will need it years from now — including features you may not add until long after move-in. Retrofits in finished homes follow the same principle in reverse: map what the walls will allow before anything gets committed, then wire it properly and program it to do what you expect without a manual.
Interested? Let's Talk.
Questions about your project, or ready to get started? Get in touch and we'll walk you through it.